retropie_packages basilisk configure before following your instructions but when I enter that I get the error message sudo. I tried starting over again after I noticed that in an article on GitHub here: it is suggested to enter sudo. Neither of the commands to start X11 you suggest at the end of part 1 starts the X11 window manager. Run BasiliskII and configure its options using the GUI.” and I’m not getting that far. I got as far as entering make, then make install, but at this point in part 2 of your tutorial you say “Start X11 on your Pi. configure without any of the disable / enable options and things seem to go OK. I explain it in the thread I started here: īasically your instructions work great right up until the.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |